April 12 14 Fernandina to Jekyll Islands Harbor Marina 23 9 Miles

Amazing! This is the 365th post to this blog since it began in October, 2010.

We were underway from 8:15 to 2:30.  We went very slowly up the west side and north side of Cumberland Island, across St. Andrews Sound and up Jekyll Creek, on the west side of Jekyll Island. A new stretch of the ICW for us. We went slow because we wanted to arrive when the tide was an hour before high. We passed the huge Kings Bay submarine base, but without sighting any of those killing machines. We passed Cumberland Landing,

on the north side of that island, where the packet boat used to land. We also passed the abandoned lighthouse and saw a buoy that has apparently detached from its mooring and washed ashore. The NY Times had a nice article about the men and women of the Coast Guard vessel that services the buoys in the NY area. In the ICW most "aids to navigation" are not buoys, but numbered red triangular and green square signs posted on pilings -- cheaper to maintain.

But this passage, with a few quite shallow patches, was deep water, 40 to 50 feet, deep enough for nuclear subs, so buoys are necessary.

This Marina is a well loved one, essentially a long dock along the east side of the creek to which all the transient boats are tied, this from its free postcard.

Here is ILENE under the live oak tree from the shower house, laundry and restaurant. Her mast, with its distinctive double forestay is in the center.

My first chore was to change ILENEs engine oil and filter. The marina takes waste oil for $2 per gallon, and I paid $2.50. We have a good pump that sucks waste oil out of the engine through the dip stick hole. You have to run the engine to get the oil hot before sucking it out but this was not a problem in that we had been running since early in the morning. But I realized that when you think you have gotten all the old oil out you have to wait to let more of it drip down to the bottom so you can suck out more of it. This time I pumped one pump to many and some oil gushed out from the bottom of the canister onto the cardboard box that I had set under it to catch spills. Im hoping I did not ruin this tool and will be able to fix it. I was also able to twist off the old oil filter without dropping it and spilling its dirty contents under the engine. Patience, and resting and drying hands just before it came off was the key. Lene helped out at the stage when you pour the dirty oil from the canister of the pump into the recently emptied oil cans for disposal. She steadied the receptacle and the funnel while I poured. No mess! Then, using a tiny bit of laundry detergent and a stiff brush, I got rid of 99% of the remaining one percent of the pelican poop from the blue canvas.
 The Marina is extremely friendly and provides good, movie watching quality, wifi; Lene has watched a lot of TV shows. They also have bicycles and a golf cart, which we used for the limit of 90 minutes per usage, for shopping at the IGA.

It is a very small store with limited selection and high prices on the east (Atlantic) side of the island, which is being developed with homes and hotels. The one drawback is insects, which bite, especially Lene. Rain has been predicted for the last week, including very high probability several of the days, but it did not come. During this passage the grey lowering skies suggested rain but it did not come until about an hour after our arrival, and lasted for about eight hours.
Because we were spending three nights and two days here, I asked the marina staff for the names of people who wash bottoms, change oil of outboards and align propeller shafts. Leo Ross, 912-266-1323, looked at the alignment, first. "Well", he said, "with the problem being intermittent and only at certain speeds, it might not be an alignment problem at all. Lets take a look."  I had cleared out the aft compartment so everything was ready for him. "Whats this? A motor mount bolt!" he quickly noted, picking it up from the bilge. It seems that the engine was held on its shock absorbing mounts by only three of the four bolts and those three were loose too. And the flange at the forward end of the propeller shaft, which is held in place on the propeller by two set screws, was also loose! After everything was nice and tight, I ran the engine at pretty high speeds in forward and reverse while tied to the dock and so far it looks good, very good indeed. But the acid test will be trying this while underway.
As to the outboard, it needed both its engine oil, which I had, and its lube oil, which I did not have, to be replaced after its 20 hour break in period. And the latter requires a special tool to force the new oil in from the bottom hole until it flows out of the top hole. I will get that tool for next time. Leo went to Westmarine on his break and bought the lube oil. He let me help him and taught me how to do this, including whacking the screwdriver with a hammer to shake lose the tight seal.

Leo looks like a refugee from that Dynasty Duck program but he is a set man, a good teacher, knowledgeable and charges a very fair amount A diver came and scrubbed the bottom and reported that my zincs have 75 to 80 percent left but that the wheel that, when not clogged by seaweed tells us how fast the boat is moving through the water (as compared to over the ground), is broken.
With all of the repair activities we did get time to use the pool and hot club, or do the sightseeing I would have liked. They have a free museum which also offers a $16 guided tour train ride through the historic old town district on the islands western side, which the Macys and Goodyears and other people of wealth set up in the 1890s. A reason to come back! Our last evening we did have a pretty good meal at the annex of the historic dowager but quite busy Jekyll Island Club Hotel, where the rich hob nobbed -- and still do. The Club sent over a van to pick us up and bring us back to the Marina.

Related Posts by Categories